Pillow block bearing pedestal type ucp

Housing, stainless steel 1.4301. Bearing, stainless steel 1.4125. Seal, rubber NBR. Note Pillow block bearings consist of a sealed singlerow ball bearing with a spherical outer ring which is mounted in a housing. Because of the spherical outer surface of the bearing, shaft misalignment can be compensated for. The bearings are manufactured with a plus tolerance. This results in transition or press fits when using shafts with htolerances. The shaft is secured by grub screws on the inner ring. In normal applications, pillow block bearings are maintenancefree due to the lifetime lubrication. In difficult environmental conditions relubrication can be carried out over the grease nipple. All housing dimensions are nominal dimensions for which the usual casting tolerances must be taken into consideration.

Housing plastic. Ball bearing stainless steel 1.4112. Plain bearing insert POM. Bushes and grease nipple stainless steel 1.4301. Version Plain bearing insert white. Housing green. Stainless steel parts bright. Note The housings are very robust, hard wearing and shock proof. They are resistant to most alkaline solutions, weak acids (PH 49) and brines. In contrast to cast or steel housings the special plastic in these housings prevent the formation of microorganisms. Drawing reference 1) ball bearing 2) plain bearing

Material Ballbearing steel 100Cr6. Seal, rubber NBR. Version Sealed on both sides with a spherical outer ring. Can be relubricated. Note The internal construction of the insert bearings corresponds to that of standard Series 6200 and 6300 radial ball bearing. However, they have wider inner rings for easier fastening on shafts. The inner rings are manufactured with a plus tolerance. This results in transition or press fits when using shafts with htolerances. The shaft is secured by 2 grub screws positioned 120° apart on the inner ring. The insert bearings are ready to install and are permanently lubricated with a suitable ball bearing grease. In normal applications, relubrication is not necessary.

Housing washer, shaft washer and rolling elements, bearing steel. Cage, steel. Note Axial ball bearings accept high axial loads from one direction but may not be loaded radially. The bearings are separable. This means the bearing parts can be fitted independently of each other. The main dimensions of the axial ball bearing conform to ISO 104 and DIN 711. Dimensional and running tolerances correspond to tolerance class PN acc. to DIN 620. These tolerance classes are standard and are well suited for most applications.